Interview program crashes the pan and tilt into the slider motor

The interview program crashes the pan and tilt motor into the slider motor. I set the Lynx up to match the icon in the controller, and so that the center slider alignment marks are visible..

It seems to make more sense to have the slider motor mounted to the right side. There is more clearance as the pan and tilt can slide over the friction knob which allows for more travel. However, when it's setup this way, the slide direction is backwards on the controller.

It would also be handy to have some options after a program runs: exit, return home, return home and re-run.

Comments

Leave a Comment

Drop image/file